Service
Inspection of finished parts
100 % quality inspection of every finished part by classical metrology methods.
Every product that leaves our workshop undergoes 100 % inspection — not merely statistical sampling. We inspect with classical metrology using calibrated instruments: calipers, micrometers, control gauges and, where needed, gauges built specifically for your geometry.
By arrangement we produce a written measurement protocol with the measured values of key dimensions. This proves that the part meets specification and forms the basis of traceability for your end application — often required by customers in energy, the tooling industry and for parts that go into regulated assemblies.
Our quality management system is certified to ISO 9001:2015. The certificate is issued by Bureau Veritas under Accredia accreditation and covers CNC turning and CNC milling; the detailed scope is available on the Quality page.
Capabilities
We perform 100 % inspection of finished parts using classical methods with classical gauges. On request we also produce a measurement protocol for the measured part.
- Lead time
- 3–5 weeks
- Response time
- within 24 hours
- Min. batch
- from 1 piece
Other services
-
01CNC turning
We turn precise round parts to your specification on five CNC lathes.
-
02CNC milling
We mill prismatic parts and complex geometries with CNC technology.
-
03Wire EDM
Wire EDM for cutting complex contours and hard materials.
-
04Laser engraving
Laser engraving for marking, serial numbers, logos and decorative patterns.
-
05Sawing
Sawing stock as preparation for further machining.